Description
JST-PH 2.0 6pin male to 6pin female 24 inch extension cable ideal for 3D printer stepper motors or any other electronics. This allows the opportunity to move your stepper motor to another location without the need to splice or solder factory wiring. Just plug this extension cable right into your original wiring that ends with a male JST-PH 2.0 connector and you’re good to go in most cases (read below).
The wires are lined up straight to each terminal end. Please review your motor’s wiring and I can work with what you need. If you would like the wires configured differently, please let me know. I can also leave one terminal end off so that you can review and line up the wires. Otherwise, the wires can be re-arranged by using a fine point pin or precision flat head screwdriver to lift the clips holding them in place.
Reviews
There are no reviews yet.